Skip to content
VAG Performance Chip
Closed ECU module · generic technical detail

Scania EMS10: OBD NR enters beta

AutoTuner adds beta OBD access for Scania Continental EMS10/CEM1. A dedicated 24V OBD cable is required.

What is new?

The source lists R- and S-series DC13/DC16 applications. MPC5777C calibration reading and checksum correction are supported. Estimated times: 7 minutes reading and 9 minutes 45 seconds writing.

Workflow and requirements

EMS10/CEM1 support is in beta. Direct vehicle connection requires the dedicated AutoTuner 24V OBD cable.

OBD connects through the vehicle diagnostic port. Normal Read reads data from the connected ECU. The memory areas covered vary by protocol.

Vehicles and engines in the release

ECU, hardware and software identification determine which specification the protocol covers.

  • Scania R — DC16 V8 16.4 l, 2018+
  • Scania S — DC13 12.7 l / DC16 V8 16.4 l

Newsletter & updates

VAG knowledge, delivered to your inbox.

Get practical tuning guides, VPC news or technical updates from AutoTuner and Magic Motorsport. Choose what you want to follow.

Subscribe to updates

No account needed. Unsubscribe at any time.

Privacy, clearly handled.

Essential cookies keep the site working. We only use analytics with your permission. Read about cookies