Skip to content
VAG Performance Chip
Closed ECU module · generic technical detail

Bosch EDC17CV41: OBD reading for agricultural and commercial vehicles

AutoTuner Tool introduces OBD NR in beta for EDC17CV41, covering applications from Case IH, New Holland, Claas and Iveco.

Access through the diagnostic port

Agricultural machinery and commercial vehicles with the supported Bosch EDC17CV41 can now be accessed through their diagnostic connector, without removing the ECU. Applications include FPT, Iveco and CNH engines in agricultural, forestry and construction equipment.

Cable and beta status

The protocol reads the calibration directly and supports checksum correction on the TC1797 controller. The ATOBD200 New Holland OBD cable is required.

This is a beta release. Approximate programming times are 2 minutes 15 seconds for reading and 1 minute 45 seconds for writing.

Vehicles and engines in the release

ECU, hardware and software identification determine which specification the protocol covers.

  • Case IH Magnum/Puma
  • New Holland T6/T7/T8/T9
  • Claas Arion/Axion
  • Steyr
  • Iveco Eurocargo/Stralis/Trakker
  • Tigercat
  • Doosan

Newsletter & updates

VAG knowledge, delivered to your inbox.

Get practical tuning guides, VPC news or technical updates from AutoTuner and Magic Motorsport. Choose what you want to follow.

Subscribe to updates

No account needed. Unsubscribe at any time.

Privacy, clearly handled.

Essential cookies keep the site working. We only use analytics with your permission. Read about cookies