Scania S6/S8: beta OBD calibration support
Motorola EMS S6 and Continental EMS S8/EMD1 gain OBD NR for Scania and selected Doosan/Develon machinery.
What is new?
Vehicle access requires the 24V OBD cable; OBD on the bench uses the S6/S8 cable. MCU: MPC555/MPC5566; checksum correction included. Listed reading times: 2:30/9:30 minutes; writing: 5:00/6:45 minutes.
Workflow and requirements
Beta. Use the 24V OBD cable on the vehicle; the Scania S6/S8 cable provides an OBD pinout on the workbench. This is not a separate native Bench protocol.
OBD connects through the vehicle diagnostic port. Normal Read reads data from the connected ECU. The memory areas covered vary by protocol.
Vehicles and engines in the release
ECU, hardware and software identification determine which specification the protocol covers.
- Scania 4 Series — P124 / R124 / T124, 11.7 l PDE/HPI
- Scania P / G / R / S — 8.9 / 9.3 / 10.6 / 11.7 / 12.7 / 15.6 l
- Scania industrial — DC09 9.3 l / DC16 16.0 l V8
- Doosan / Develon DX380 LC-7 / DX530 LC-7 / DL420-3 / DL420-5 / DL450-5
- Moxy MT31 — 9.0 l