Skip to content
VAG Performance Chip
Closed ECU module · generic technical detail

Delphi DCM7: OBD access for pickups and commercial vehicles

AutoTuner adds OBD NR for DCM7.1AP and DCM7.24, including applications from GWM, Isuzu and Foton.

What is new?

Calibration readout uses OBD, with TC277 and checksum correction. Quoted reading time is 2 minutes 45 seconds; writing takes about 3 minutes. Examples include GWM POER, Isuzu Taga and Foton Tunland.

Workflow and requirements

OBD NR directly reads calibration from the TC277 controller. DCM7.1AP and DCM7.24 have distinct vehicle applications, as outlined below.

OBD connects through the vehicle diagnostic port. Normal Read reads data from the connected ECU. The memory areas covered vary by protocol.

Vehicles and engines in the release

ECU, hardware and software identification determine which specification the protocol covers.

  • GWM POER / Haval / Wingle — 2.0 TD GW4D20M / GW4D20D, DCM7.1AP
  • Isuzu 100P / KV100 / KV600 / NKR / Taga / Taga H — 3.0 TD, DCM7.1AP
  • Foton Tunland / Toano / View — 2.4 TD, DCM7.24
  • Foton Aumark / Forland / Ollin — 4.2 TD / 4.3 TD, DCM7.24
  • JAC T8 Pro / T9 — 2.0 CTI, DCM7.1AP
  • Dongfeng Rich / Captain — 2.3 TD / 2.4 TD, DCM7.1AP
  • Changan Hunter F70 — 2.0 TD; JMC Yuhu — 2.0 TD / 2.8 TD, DCM7.1AP

Newsletter & updates

VAG knowledge, delivered to your inbox.

Get practical tuning guides, VPC news or technical updates from AutoTuner and Magic Motorsport. Choose what you want to follow.

Subscribe to updates

No account needed. Unsubscribe at any time.

Privacy, clearly handled.

Essential cookies keep the site working. We only use analytics with your permission. Read about cookies