BMW DME8: improved patch requires a fresh Bench unlock
AutoTuner improves the OBD unlock patch for several BMW DME8 controllers. It addresses FSC activation faults that could appear after writing modified software.
What is new?
An ECU already using the previous patch also needs a fresh Bench unlock before using the improved OBD workflow.
Workflow and requirements
Previously patched ECUs also need a fresh Bench unlock. The revision addresses FSC faults 1B2904 and 1F2102, sometimes accompanied by 021204 or 21B210, after OBD writing.
OBD connects through the vehicle diagnostic port. Bench uses the controller connector pins outside the vehicle connection.
Vehicles and engines in the release
ECU, hardware and software identification determine which specification the protocol covers.
- BMW DME8 — MG1CS024 / MG1CS049 / MG1CS201