FLEX update archive: earlier OBD, Bench and Boot releases
The technical essentials of eight earlier FLEX reports, from version 5.0 to 7.5. Historical reference with ECU types and conditions, not current coverage guarantees.
Eight earlier FLEX releases, from OBD access for Bosch controllers to Boot for older systems. This overview covers support described in November 2024. Current vehicle coverage and software identification determine the route for work today.
FLEX 5.0.0.0 — OBD for several ECU families
The original report covered Bosch MEVD17 and EDC17 for BMW and MINI, EDC16/MED9 CAN and K-line for VAG, and MEDC17 TP2.0. Kia and Hyundai MEDC17 applications were also mentioned. This concerned diagnostic-port programming for supported combinations, not every vehicle from those brands.
FLEX 6.18.0.0 — VAG datalogging
This release concerned the Datalogger for Audi, CUPRA, Porsche, SEAT, Škoda and Volkswagen. The report described more than forty engine management systems and configurable parameters. Datalogging records measurements; it is not a new writing or unlocking method. Available signals depend on the system.
FLEX 6.38.0.0 — Bosch MD1 diesel through OBD
The listed controllers were MD1CS004, MD1CP004 and MD1CP014. The archive describes a virtual read and unlocking during writing, with Maps and Maps & Code for supported versions. Hardware and software identification remain necessary: an ECU family name does not confirm identical support for every version.
FLEX 6.39.0.0 — MG1CS002 and MG1CS008
This OBD release concerned VAG applications with 3.0- and 4.0-litre petrol engines. An available virtual read was part of the described workflow, which also included Maps & Code. A vehicle model name alone does not establish compatibility.
FLEX 6.40.0.0 — MG1CS001, MG1CS011 and MG1CS111
The report described OBD access for these Bosch controllers in 1.0-, 1.5- and 2.0-litre VAG petrol applications. A virtual read matching the software version was a critical condition. Without it, the described unlock route did not apply. Do not confuse this earlier OBD release with later Boot Glitch or Bench solutions for different hardware versions.
FLEX 6.55.0.0 — Porsche hybrid modules through Bench
The archive lists Bosch INVCON2.1 and BMS for selected Porsche hybrids, including Flash, EEPROM and full backup access. These are specific inverter and battery control modules, not a general Stage 1 promise for a hybrid Porsche.
FLEX 6.58.0.0 — Porsche Bosch MG1CS047 through OBD
This release concerned MG1CS047 and Virtual Read, writing and checksum functions for Maps and Maps & Code. A suitable virtual read was again required. The original report mentioned a possible software update to a supported version; that option needs checking against current supplier information.
FLEX 7.5.0.0 — Boot for older engine controllers
This release described seventeen Boot applications for older controllers. Examples included FCA Marelli IAW 4AF, Ford Delphi DCU101, Mercedes Bosch ME2.7.1 and Opel Bosch ME7.6.4.
What does this mean for your car?
A protocol provides software access; it does not specify a power increase. Before work, check the current FLEX vehicle list, hardware, software and applicable conditions. Other methods may now be available. Send your vehicle details and requirements to VPC for an assessment of your current configuration.